Recommended starting point
xTool D1 Pro 20W settings for Powder Coated Stainless Tumbler
These rows are baseline laser settings for Powder Coated Stainless Tumbler on the xTool D1 Pro 20W. Use them to start calibration, then run a small test cut or test engrave on scrap from the same batch before production work.
Calibration table
Use these as starting points for your own machine log.
| Thickness | Action type | Speed mm/s | Power percent | Passes | Air assist |
|---|---|---|---|---|---|
| N/A | engrave | 45 | 80% | 1 | No |
Quick FAQs
Are these xTool D1 Pro 20W settings guaranteed for Powder Coated Stainless Tumbler?
No. Treat them as recommended starting points. Run a small test cut or engrave before you use a full sheet or finished part.
Why does 20W matter?
Wattage affects how much energy can be delivered at a given speed. A lower wattage machine may need slower speed or more passes than a higher wattage machine.
Should I change air assist for Powder Coated Stainless Tumbler?
Follow the row when air assist is listed, then adjust during testing. Air assist can reduce flare-ups and improve cut edges, but some engraving jobs may need less airflow.